Building instructions for paper Helica. Sorry about the translation, I have done it with the « help » of an automatic translator....if you can tell me all the mistakes, I will very happy to improve this text. The scale is 1/40 when the drawing is on an A4 format. Printing on normal paper. Tools: Scissors, Cutter, Patience. Cut two half-wheels 1 then to stick them, the hole of inflation will have to be thereafter on outside. Same thing for other wheel 2; they are the rear wheels. Even thing for wheels 3 and 4, the brake drums will be interior side during the assembly. Front axle 5; fold along the line after having notched the half-wheels until their center. Once folded, one obtains a flat axis and with each extremity a half-wheel to stick the wheel. To put adhesive only on the part which becomes the axis. Once dryness, stick the nose gear wheels. Rear axle 6, fold the part along the line after having notched the half-wheels until their center. Not to put of adhesive on the half-wheels. Once dryness, to cut out with the cutter the white triangles. Stick the rear wheels. Protection of propeller 15, it acts of the external part, form a circle then stick the strip. Put glue on the totality of the interior circle 14 then put it inside circle 15. Put the black strips which exceed well opposite for the 2 circles, not stick them. Slip the front axle into the strips then sticking it after having well centered. Cut out engine 9, roll (by ex on a toothpick) to form it, then stick the strip, then fold the small strips and to fold up the cylinder heads, stick. Cut out the two faces of propeller 8, stick. Stick then on the black spot of the engine, blades with 45°. Support rings protection 20. Fold according to the axis, stick then cut out the white part. Fold at 90° the ends, stick on the black spots of the circle of protection. Half-stabilizers 16 and 17. Fold up and stick without putting of adhesive on the strip of fixing at the carossery. Fold this strip at right angle 90°. Mudguard 18 and 19, fold up and stick, not put adhesive on the black strip. Form the mudguard then stick the strips on the white spots on the circle of protection. Front seat 11. Fold up the black part then stick it, fold with 90° gray part and still with 90° the white part. Same thing for the rear seat 12. The 2 seats must be formatted like fabrics of deckchair. Part 23. It is the interior hull of the carossery. The 2 partitioned parts represent the interior sides, the part with the 2 rectangles white, the interior floor, the last part, the external bottom. Notch the black circle using a cutter to fix the rear wheel-axle later. Fold with 90° the strips, paste them, they will be outside the assembly, to format. Ending by folding up the external lower part. Think of giving again a blow of cutter to bore the 2 thicknesses at the place of the fixing of the rear axle. Outside of hull 13. Not to forget to notch the dashboard in its center as well as the part before cap. Also make the notches for support 20. Fold with 90° the sides compared to the yellow part. Format without sticking the cap. Present the external part on the lower part. Improve if need be the interior part. Then stick the external sides on the interior part. Stick the cap in form. Stick wheel 3. Stick support 20 on before and to put the ties in the notches of the cap. In option, format the engine support 10. Glue the motor, improve the blades of propeller to ensure the passage in the circle of protection. Stick the rear axle, put in option the draft at the stern 7 after having folded up it on him even. Stick in option the front suspensions after having folded them on themselves. Stick the seats on the white sites. Admire your work!!!! Claude